Uniseal
ENQUIRE NOWSKU-U018 Pipe ID 3/16" Pipe OD 6mm
SKU-U025 Pipe ID 1/4" Pipe OD 10mm
SKU-U038 Pipe ID 3/8" Pipe OD 17mm
SKU-U050 Pipe ID 1/2" Pipe OD 21mm
SKU-U075 Pipe ID 3/4" Pipe OD 27mm
SKU-U100 Pipe ID 1" Pipe OD 33mm
SKU-U125 Pipe ID 1.1/4" Pipe OD 42mm
SKU-U150 Pipe ID 1.1/2" Pipe OD 48mm
SKU-U200 Pipe ID 2" Pipe OD 60mm
SKU-U300 Pipe ID 3" Pipe OD 89mm
SKU-U400 Pipe ID 4" Pipe OD 114mm
SKU-U400-35 Pipe ID 4" Pipe OD 110mm
SKU-U600 Pipe ID 6" Pipe OD 168mm
SKU-U600-35 Pipe ID 6" Pipe OD 160mm
- Long Life
- Easy to install
- Replaces most bolt-on flanges
- Can withstand suction, acids and oils, sewerage
and waste, heat and cold - 3-12mm Wall thickness
- Cut hole to the Holesaw size indicated for the UNISEAL® you are using. (see above). Example: 3” UNISEAL® = 4” Hole (Holesaw).
- Ensure that the hole is clean cut with sharp edges. Irregularities could cause poor seating and leakage.
- Insert the UNISEAL® into the hole with the wide side facing the pipe to be inserted.
- Make certain that the pipe end to be inserted is clean cut. File the edges so that there are no sharp points to cut UNISEAL®.
- Using Detergent, lubricate the outside of the pipe end to be inserted, then push the pipe through the UNISEAL® from the large flange side. The detergent will be squeezed off as the pipe passes through the UNISEAL®. The co-efficient of friction of the rubber holds the pipe tightly in place.
No content found
No content found